How to switch connection modes

The FITLIGHT® can connect in one of two modes - either via WiFi or Bluetooth. Depending on when you purchased your system, you may have access to one mode or both. 

To switch connection modes, click the menu bar's status (battery icon). 

The connection status of the master light (light that connects with your device & other lights) is indicated here. The system has several connection types, and available connection types depend on when you purchased the system. To check the connection types, tap the area where the menu will appear.

There are 3 connection types. Please note not all connection types apply to all systems.

WiFi classic: Systems with the WiFi light that has the network name FITLIGHT_########

WiFi new: Only available for systems purchased in March 2024 and after. The WiFi connection will show as AP. Any systems where the 6 digit in the serial number is a 5 (i.e., 240651111). 

Bluetooth: Only available systems purchased in March 2024 and after. The system will allow you to connect via Bluetooth. Any systems where the 6 digit in the serial number is a 5 (i.e., 240651111). 

See here for switching modes for connections.

If all three connections are marked, the system will cycle through each connection to the first connection it finds. If you would like to use the system with a specific type of connection only, ensure only that connection is selected.

Troubleshooting Tip & Tricks:

1. My app's status stays red but is connected to the Master light.

Close and reopen the app. Give the app a few seconds to connect. After about 10-15 seconds, you should get a message that indicates you are connected to the app.

2. I am connected, but FITLIGHTS® in setup, say 0

Close the app. Turn off both the WiFi & Bluetooth settings on your device. Turn on the WiFi & Bluetooth settings. Open up the app again and give it a few moments. 

If it does not connect, ensure the desired connection mode is turned on. For more on connection modes, see here: 

3. I switched modes, and it says Bluetooth Or WiFi light connected, but it says FITLIGHTS in setup 0

Completely close the app and open it again. Give it a few seconds to connect again. Just to let you know, you will receive a message that indicates the connection was successful.

See more troubleshooting tips here: